![]() Moca adapters connected to coax in each room WITHOUT the modem So if that Antronix amp is out of the question, what would you recommend that can split to a max of 4 rooms? And if the TV specs below are not enough, which Moca splitters can you recommend for the modem area?īut just to be sure I'm understanding this correctly:ģ. (But given the stop-band for the amp’s built-in “PoE” MoCA filter, all MoCA adapters would need to be configured for this more limited MoCA frequency range regardless of whether the D3.1 “initial rollout” frequencies are in use.). That said, the cited amp would allow coexistence of MoCA and DOCSIS 3.1 “initial rollout” signals on shared coax, provided all MoCA devices are configured to operate in the 1275-1675 MHz range. See: DOCSIS encroachment on the MoCA frequency range So unless your provider is definitely using DOCSIS 3.1 frequencies above 1002 MHz, I still wouldn’t recommend using an amplifier and least of all this amp. Per its specs, this appears to be an amp designed for cable TV and DOCSIS 3.1 “initial rollout,” and with the expectation that any MoCA devices will be configured to operate with a starting frequency of 1275 MHz or above, rather than 1125 MHz. It's the red amp at the bottom of this page. (The only output port on an amp not affected by the amp losing power is the passive output port, typically labeled “VOIP.”) Ideally you’d return it and just use the suggested passive configuration - again, assuming the current passive configuration is working.īut using the amp and not plugging it in would be more harmful to the incoming signal, I believe. Just wondering if I don't plug it into a power outlet, won't it act just like a regular splitter without amplification? I already have a moca amp/splitter with an integrated PoE filter and 8 outputs. Also does anyone have experience with the starlink adapters and if anyone knows what configs have to be done with them? Or if there's another brand you would recommend? I've heard about screenbeam and gocoax but these only come in 2-packs and starlink's 3-pack is the same price as those. we can just connect that to the basement moca amp?Īre there any configs that need to be done with the modem – it will be in bridge mode and I'm not planning to use its moca function. we would like to use the coax in the basement for the third adapter.main floor: A) coax to adapter B) ethernet from LAN1 of adapter to modem 2.5 gb port C) ethernet from LAN2 of adapter to router 2.5 gb port D) connection to pvr, roku from router unchanged.basement: moca amp with integrated filter to replace current splitter.Also ordered an ASUS AX-86U which would be a major upgrade over my existing Apple Airport Extreme. I'm planning to purchase the starlink 3 pack moca adapters from amazon. Just want to confirm if my proposed moca solution would work. we have an additional coax in the basement which we want to utilize for an access point.2nd coax goes to second floor office (modem/router were located here before we switched to ignite).1st coax goes to main floor to xb7 modem (bridge mode), ethernet to router WAN, LAN ports from router to rogers pvr and roku.inbound cable in basement (split 2 ways).We don't have any ethernet/telephone wiring but a bunch of coax outlets so moca would prob be our best solution. ![]() Just looking to get faster connection around the house to maximize this bandwidth and I've been reading about moca. We just renewed our plan and got the Ignite 1.5 GB bundle with tv.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |